3. Raspberry Pi Configuration

RPi-Spark requires the Raspberry Pi's I2C, SPI, and Serial ports to work properly, so we need to configure the Raspberry Pi to open these ports before using RPi-Spark.

Enter the following command in the terminal:

sudo raspi-config

Configuration interface:

raspi-config

We configure the SPI port:
raspi-config open SPI

raspi-config enabled SPI

Next in the same steps, we configure the I2C port:
raspi-config open I2C

Configure the Serial port:
raspi-config open Serial

Configure Camera:
raspi-config open Camera

Through the above steps, we can use RPi-Spark now.


 

Was this article helpful?

YES     |     NO

 

Enjoying the project? Spotted a mistake? Any opinions on the website? Let us know!